A better finish starts underneath.
Repair first. Coat second. The slab determines the work.
Preparation is not the opening act.
It is the foundation of the entire job. Cracks, worn areas, old surface material and the edges of the slab all need to be understood before a coating system is chosen.
Every floor is different. An on-site look is the honest way to define the repair and preparation scope.
What happens before coating.
- Inspect the slab
Look at damage, prior coatings, movement, moisture concerns and how the garage is used.
- Address repair areas
Define what can be repaired and explain any condition that may affect the finished result.
- Mechanically prepare
Open the surface so the selected coating can be installed over properly prepared concrete.
- Detail the perimeter
Work through edges, transitions and hard-to-reach areas instead of treating them as an afterthought.
- Clean for coating
Remove preparation residue and leave the slab ready for the finish system.